Silk-n SKINVIVID TB-1389 Mode D'emploi page 18

EN the massage mode
the SkinVivid is in the mode for the hot massage.
2. Push the control knob again to additionally switch on the sound
vibration.
A beep tone will sound and, in addition to the top light, the
bottom light of the indicator for the massage mode will illumi-
nate in yellow at the same time. The SkinVivid is in the mode for
hot massage with sonic vibration.
3. To switch to the mode for cold massage, push the control knob
again.
A beep sound will be emitted, the light in the middle of the
indicator for the massage mode will illuminate in blue and
indicate that the SkinVivid is in the mode for the cold massage.
4. Push the control knob again to additionally switch on the sound
vibration.
A beep tone will sound and, in addition to the middle light, the
bottom light of the indicator for the massage mode will illumi-
nate in yellow at the same time. The SkinVivid is in the mode for
cold massage with sonic vibration.
5. Move the SkinVivid up to your face and place the massage
8
head
6. Depending on the part of your skin you are treating, allow the
SkinVivid to glide in circular movements from the inside to the
outside or from top to bottom.
7. To switch the SkinVivid off, hold the control knob down for
3 seconds.
A beep tone will be emitted and the lights in the indicator for
the massage mode will go out.
18
2
will illuminate in red and indicate that
on the desired part of your face.