Water Ace RTS5 Manuel D'installation page 10

REMINDER: ALL JOINTS AND CONNECTIONS MUST BE AIRTIGHT. A SINGLE PINHOLE
LEAK WILL PREVENT THE PROPER OPERATION OF THE PUMP. USE THREAD COMPOUND
ON ALL THREADED CONNECTIONS UNLESS SPECIFIED OTHERWISE.
Process C. 3. Install a deep well pump with a packer
TO INSTALL THE RC10 & RC5
Open packer ejector kit. Thread foot
STEP
valve RFV-10 onto packer ejector.
1
Thread the venturi tube into other
side of packer ejector.
Slide the fi tting from packer ejector
STEP
kit over venturi tube and thread
2
onto packer ejector. Thread a 1"
male PVC adapter into the brass
fi tting.
Subtract seven feet from the
STEP
depth of your well. This is the
3
total length of rigid 1" PVC pipe
and couplings to cement onto the
1" male PVC adapter. Cement one
section of rigid PVC pipe to the
male PVC adapter, then lower the
whole assembly into the well, foot
valve fi rst. Firmly clamp the end
of the rigid PVC pipes with a pipe
clamp to prevent the assembly
from sliding down into the well.
Cement as many couplings and
sections of rigid 1" PVC pipe as it
takes to equal the depth of your
well minus seven feet, then fi rmly
clamp the assembly with a pipe
clamp to prevent the assembly from
sliding down into the well. Clamp
the assembly so approximately
twelve inches of rigid 1" PVC pipe
protrudes from the well.
23833A472
Open packer well adapter kit
STEP
SMALL
RWA-2. Slide compression
4
BORE
plate and rubber compression
VENTURI
TUBE
gasket over rigid 1" PVC pipe
protruding from well.
PACKER
EJECTOR
FOOT
Thread 1" x 8" nipple into
VALVE
STEP
bottom of packer well adapter.
5
Thread 1" female PVC adapter
onto 1" x 8" nipple. Thread
3/4" plug into top of packer
1" MALE PVC
well adapter.
ADAPTER
FITTING
Cement packer well adapter
STEP
assembly to top of rigid
6
1" PVC pipe protruding
from well.
Remove pipe clamp. Line
STEP
up the holes in well casing,
7
compression plate, and packer
well adapter and fasten them
together with the three nuts
and bolts provided in packer
well adapter kit RWA-2.
9
COMPRESSION
GASKET
COMPRESSION
PLATE
WELL
CASING
3/4" PLUG
PACKER
WELL
ADAPTER
1" X 8"
NIPPLE
1" FEMALE
PVC
ADAPTER
1" FEMALE
PVC
ADAPTER
PVC PIPE
PROTRUDING
FROM WELL
BOLTS
WELL
CASING