Selecting Mode - Panasonic EY7549 Instructions D'utilisation

Switch and Forward/Reverse
Lever Operation
Forward
Switch lock
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the
amount of depression of the trigger
for efficient tightening of screws and
drilling. The brake operates and the
chuck stops immediately when the
trigger is released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation.
Check the direction of rotation be-
fore use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).

Selecting Mode

Select mode Intended use Work material Maximum size
Impact
Drill driver
Reverse
High mode
Drill driver
Low mode
WARNING!
This tool must not be used as a drill in
"Impact Driver mode". During drilling in
steel, the drill bit may break in case of
blocking and this may cause dangerous
cut wounds.
Impact Driver Operation
Select Impact with the mode select
switch.
• Switch to the Impact or Drill driver
High/Low position only when the tool
has completely stopped rotating.
Damage may be caused if the tool is
rotating.
Drill Driver Operation
Select Drill driver High or Low mode
with the mode select switch.
• Switch to the Impact or Drill driver
High/Low position only when the tool
has completely stopped rotating.
Damage may be caused if the tool is
rotating.
- 13 -
Fastening Bolt
High tensil:M12
Nut Standard :M14
Driving Wood screw ø 9mm
Self-drilling screw ø 6mm
Driving Wood screw ø
4.2mm
ø
Self-drilling screw 6mm
Drilling Wood ø 21mm
ø
Metal 10mm
Driving Wood screw ø 6.8mm
Drilling Wood ø
35mm
ø
Metal 13mm