Elem Garden Technic RO24V32 Traduction Des Instructions D'origine page 51

H) After all the fence line is fixed, reserve 10-15cm terminals respectively for both front and tail
ends. Strip the terminals to reveal the copper lines for 2-3cm (Fig. A). Remove the nuts, fasten
the copper lines on copper conductors. Then tighten the nuts (Fig.B). Front tail connect with the red
pole, rear tail connect with the black pole. When the charger is connected to
the charging station and the fence line starts to operate, the red lamp should be off.
Fig. A
Note: Do not fold or repeat wiring with the rest fence line. Cut it instead (Fig. C)
Mowing Height:
The mowing height can be adjusted by changing the blades or adjust its position. There are
3 mowing heights using 2 different kinds blades. Detach the blade with a spanner and attach it
again into the desired position.
Note : Make sure that the power key and fuse are not inserted.
Fig. B Fig. C