Storch Airless ST 1700 Mode D'emploi page 188

ger the gun and turn up the pressure regulator by 1/2 turn.
Flush 1 minute.
High-pressure spray is able to inject toxins into the body
and cause serious bodily injury. Do not stop leaks with
hand or rag.
7. Inspect for leaks. If leaks occur, perform Pressure Reli-
ef Procedure. Tighten fittings. Perform steps 1 - 5 of com-
missioning. If not leaks occur, continue with step 8.
8. Place the siphon tube in the paint container.
9. Trigger gun again into flushing pail until paint appears.
Move gun to paint pail and trigger for 20 seconds.
10. Engage trigger lock. Assemble tip and guard, see
instructions on next page.
Original instruction
Switch Tip Installation
1. Perform Pressure Relief Procedure.
2. Use spray nozzle (A) to insert seal (B) into guard (C).
3. Insert Switch Tip.
4. Screw assembly onto gun. Tighten.
Spray
188