Safety Notes; Applications - IMG STAGELINE MATRIX Mode D'emploi

2 Safety Notes

The unit corresponds to all required directives of
the EU and is therefore marked with
WARNING The unit is supplied with hazardous
mains voltage. Leave servicing to
skilled personnel only. Inexpert han-
dling or modification of the unit may
cause an electric shock hazard.
It is essential to observe the following items:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not place any vessels filled with liquid, e. g.
drinking glasses, on the unit.
G
Do not set the unit into operation, or immediately
disconnect the mains plug from the mains socket if
1. there is visible damage to the unit or to the
mains cable,
2. a defect might have occurred after a drop or
similar accident,
3. malfunctions occur.
The unit must in any case be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the mains socket, always seize
the plug.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely mounted or not correctly operated, or not
repaired in an expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in ac -
cord ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol , or coloured green or green and yel-
low.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
.
Warning – This appliance must be earthed.

3 Applications

The unit LED-345RGBW is suitable for applications
on stage, in discotheques, clubs or party rooms
and is used for effect illumination. It creates chang-
ing patterns over a large area consisting of red,
green, blue and white light points. A music-con-
trolled light show is possible via the integrated
microphone. As a light source, 256 super bright
LEDs are used which feature a low power con-
sumption, a low heat development and a long life.
The light effect unit is designed for operation via
a DMX light controller (32 or 3 DMX channels at
option). However, it can also be operated without a
controller, either as an individual unit or intercon-
nected with several LED-345RGBW units in the
master / slave mode.
4 Mounting
G
Always place the unit so that a sufficient air cir-
culation is ensured during operation. The air
vents at the housing must not be covered in any
case (e. g. by curtains).
G
The distance to the illuminated surface should be
50 cm as a minimum.
Fix the light effect unit via its mounting bracket (1)
to a suitable place, e. g. with a stable mounting
screw or a support for lighting units (C hook) to a
cross bar. To align the unit, release the two locking
screws (2) at the bracket, adjust the desired incli-
nation and retighten the screws.
WARNING The light effect unit must be mounted
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
in a safe and expert way. If it is
installed at a place where people
may walk or sit under, it must addi-
tionally be secured [e. g. by a safety
rope; lead the safety rope through
the safety lug (3) and fix it so that the
maximum falling distance of the unit
would not exceed 20 cm].
GB
11