Connecting with a paired BLUETOOTH
device
To use a paired device, connection with this unit is
required. Some paired devices will connect
automatically.
1
Press HOME, then touch [Settings].
2
Touch [Bluetooth].
3
Touch [Bluetooth Connection], then touch
[ON].
Make sure that
lights up on the status bar of
the unit.
4
Activate the BLUETOOTH function on the
BLUETOOTH device.
5
Operate the BLUETOOTH device to connect
to this unit.
or
lights up on the status bar.
To connect the last-connected device from
this unit
When the ignition is turned to on with the
BLUETOOTH signal activated, this unit searches for
the last-connected BLUETOOTH device, and
connection is made automatically.
Note
While streaming BLUETOOTH audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead.
To install the microphone
For details, see "Installing the microphone"
(page 28).
Connecting a USB Device
1
Turn down the volume on the unit.
2
Connect the USB device to the unit.
To connect an iPhone, use the USB connection
cable for iPhone (not supplied).
Connecting Other Portable Audio
Device
1
Turn off the portable audio device.
2
Turn down the volume on the unit.
3
Connect the portable audio device to the
AUX input jack (stereo mini jack) on the unit
with a connecting cord (not supplied)*.
* Be sure to use a straight type plug.
4
Press HOME, then touch [AUX].
To match the volume level of the connected
device to other sources
Start playback of the portable audio device at a
moderate volume, and set your usual listening
volume on the unit.
During playback, touch
Level]. Adjust the volume level between [-10] and
[+15].
Connecting Rear View Camera
By connecting the optional rear view camera to the
CAMERA IN terminal, you can display the picture
from the rear view camera. For details, see
"Connection/Installation" (page 26).
To display the picture from the rear view
camera
Press HOME, touch [Rear Camera].
, then touch [Input
9
GB