Dirt Devil Classic Mode D'emploi page 30

Operating
1
2
1
1
1
30
1. Push on the desired nozzle,
nozzles (accessories)".
2. Pull the cable holding the plug (Fig. 1/15) until the
yellow mark (Fig. 10/1) is reached.
WARNING:
2
If the red mark (Fig. 10/2) is visible, then retract the cable
again until it is no longer visible,
Fig. 10
"Switching off and retracting the power cable". Otherwise
the cable can break off. There is a risk of electric shock.
3. Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 11/1).
4. Turn on the suction using the suction controller (Fig. 11/
2).
Fig. 11
5. Adjust
depending on the type of flooring:
- Hard floor (Fig. 12/a)
a
Laminate flooring, tiles, PVC flooring, etc.
- Carpet (Fig. 12/b)
Long and short fibre carpets, runners, etc.
b
Fig. 12
6. To vacuum, pull the cylinder vacuum cleaner behind
you like a sledge. When vacuuming, observe the
corresponding
manufacturer.
NOTE:
You can quickly reduce the suction power with the
secondary air controller (Fig. 13/1) , e.g. to release
curtains that have been sucked in.
Fig. 13
Chapter 2.3, "Using other
the carpet/hard floor
recommendations
Chapter 3.2,
switch (Fig. 12/1)
of the flooring