Parts Description; Technical Data; Safety; Safety Information - LIVARNO LUX 14118405L Instructions De Montage, D'utilisation Et Consignes De Sécurité

Parts description

Lamp head
1
Dimmer switch
2
Lamp arm
3
Tube (14118405L / 14118406L)
4
Upper tube (14118405L / 14118406L)
4 a
Lower tube (14118405L / 14118406L)
4 b
Base
5
Mains plug
6
Locating screws (14118405L / 14118406L)
7
Connector (metal) (14118405L / 14118406L)
8
Screws (14118502L)
9
Lead
10
Mains cable (14118405L / 14118406L)
11
Wing bolt (14118405L / 14118406L)
12

Technical Data

Model no.: 14118405L / 14118406L
Operating voltage:
Rated power (light):
Light bulb:
Total height, arm 90°: approx. 1300 mm
Protection class:
Model no.: 14118502L
Operating voltage:
Rated power (light):
Light bulb:
Total height, arm 90°: approx. 1500 mm
Protection class:

Safety

Safety information

Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
230 V∼, 50 / 60 Hz
6.5 Watt
1 LED module (LED
module not replaceable)
II /
230 V∼, 50 / 60 Hz
11.5 Watt
1 LED module (LED
module not replaceable)
II /
injury due to improper handling or failure to comply
with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Check the light for damage every time before
you use it. Never use the light if it shows any
signs of damage.
CAUTION! A damaged light means danger
of death from electric shock. In the event of
damage, repairs or other problems with the light
please contact the service centre or a qualified
electrician.
To prevent hazards, a damaged flexible outer
lead on this lamp must be replaced by the man-
ufacturer, its service representative or an equally
qualified professional!
Before use, verify the available mains voltage
corresponds with the operating voltage of the
lamp (see „Technical Data").
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Always unplug from the mains before assembling,
disassembling, cleaning, or if the lamp will not
be used for extended periods.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
The LED module in this light cannot be replaced;
if the LED module has reached the end of its life,
replace the entire light.
Prevent fire and
injury hazards
RISK OF INJURY! Check every illuminant for
damage immediately upon unpacking. Do not
install the light if the illuminants are defective.
In this case contact the service centre for a re-
placement.
Do not look directly into the illuminant (lamp, LED,
etc.). Do not look into the illuminant (lamp, LED,
etc.) with an optical instrument (e.g. magnifier).
Introduction / Safety
GB/IE/NI 7