Seca 808 Mode D'emploi Et Garantie page 19

7. What do I do if...
... no weight display comes on?
– Is the scale switched on?
– Check the batteries.
0. 0
... does not appear before weighing?
– Start the scale again after it switches off automatically – there must not be any load on
the scale – and only its feet should be in contact with the floor.
Err 2
... the message
– You should carry out the measurement barefoot, otherwise there is insufficient contact
with the sensors. If you have very dry skin, moisten your feet slightly to improve con-
ductivity.
... the values for body fat and body water deviate significantly from the standard
values?
– Stand as still as possible during measurement.
– Place both feet as completely on the sensors as possible (see Fig. 6).
– Have you entered your height correctly? Switch on the scale with the key assigned to
your personal memory and then press one of the arrow keys L and M. The symbol for
your personal memory will flash and the entered data will be shown. Check this and
amend if necessary (see "Storing personal data" on page 12).
– In the following cases, measurement will give implausible results: during pregnancy or
if your body contains medical implants such as artificial joints, metal plates or screws.
In such cases, you should have your doctor carry out a differential diagnostic exami-
nation to obtain correct results.
– People with a high body fat value very often have a below-average body water value.
– Very athletic people with little body fat and high muscle mass often exhibit values
above the guidelines. In this case, select the 'Athletic' option for your build.
... the values for body fat and body water deviate significantly between different
measurements?
– Wherever possible, perform measurements each day at the same time and under the
same conditions, e.g. 15 minutes after getting up.
– Measurements taken directly after sleeping give implausible results because body wa-
ter is distributed differently throughout the body during sleep.
– Measurements taken directly after strenuous physical exercise also give implausible re-
sults. Take a relatively long break before measuring.
– A heavy meal or drinking alcohol also give implausible results.
... one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
... the display shows
– Battery voltage is running low. Change the batteries in the next few days.
batt
... appears in the display?
– Batteries are empty. Put in new batteries.
St0p
... appears in the display?
– Maximum load has been exceeded.
16
appears when measuring body fat and body water values?
?