About The Manual; Dimensions - Harman JBL Cruise X Guide De Démarrage Rapide

THANK YOU FOR YOUR PURCHASE . . .
Your JBL product is designed to provide you with the
performance and ease of operation you would expect from JBL

ABOUT THE MANUAL

This manual provides general installation guidelines. However,
please note that proper installation of mobile audio components
requires qualified experience. If you do not have the knowledge
and tools to successfully perform this installation, we strongly
recommend consulting an authorized JBL dealer about your
installation options. Keep all instructions and sales receipts for
reference.
4X
1X

DIMENSIONS

4-3/16" (106mm)
116" (2947mm)
3" (76.5mm) 1-3/8" (34mm)
1" (25.4mm)
Remote Control
EN
Cutout Diameter
8-5/16" (211.1mm)
1
16X
4X
4X
1X 1X 1X
6X 2X 4X
7-3/4'' (195.8mm)
Cruise X
MOUNTING THE AMPLIFIER
Recommendations: choose a location protected from debris,
and the elements, which will not interfere with vehicle operation.
Using the included stainless steel screws is the preferred method
for securing the amplifier to the mounting location.
NOTE: Before securing the amplifier with mounting screws,
check beneath the mounting surface to ensure you will not
puncture fuel lines, brake lines, or any vehicle wires.
WIRING FOR POWER AND GROUND
Remote out (blue/white)
+12V (yellow)
Remote in (blue; to vehicle +12V ACC switch or optional toggle switch)
Ground (black)
Chassis ground (–) or
Ground to battery (–)
Battery
1. Connect the amplifier +12V power wire (yellow) to the positive
(+12V) terminal of the vehicle's battery.
2. Connect the remote in wire (blue) to the vehicle's 12-volt
accessory switch (such as the ignition switch).
3. Connect the ground wire to the vehicle's chassis using a
sheet metal screw and washer, or directly to the negative
(ground) terminal of the vehicle's battery. Be sure to scrape off
any paint at the chassis ground location with sandpaper first.
4. OPTIONAL: Connect the remote out (blue/white) wire to the
remote in wire of an optional accessory powered subwoofer,
JBL sound bar, or second Cruise X.
NOTE: If your vehicle does not have a 12-volt accessory switch
for remote-in, you can use a 2-way 12-volt toggle switch (not
included) to turn the amplifier on/off. In this case, you will need to
turn the switch off when not using the audio system to keep from
draining your battery.