Replacing The Shaving Heads - Philips 9000 Série Mode D'emploi

22
English
2 Put the protection cap on the cleansing brush attachment to
protect it from dirt accumulation (Fig. 60).
Replacement

Replacing the shaving heads

For maximum shaving performance, we advise you to replace the
shaving heads every two years (Fig. 61). Replace damaged shaving
heads immediately. Always replace the shaving heads with original
Philips shaving heads (see 'Ordering accessories').
Replacement reminder
The replacement reminder indicates that the shaving heads need to
be replaced.The shaving unit symbol lights up continuously, the
arrows flash white and you hear a beep when you switch off the
shaver (Fig. 11).
1 Switch off the appliance.
2 Pull the shaving head holder off the bottom part of the shaving
unit (Fig. 52).
3 Place the retaining ring holder on the retaining ring (1), turn it
anticlockwise (2) and lift it off the shaving head (3) (Fig. 62).
Remove the retaining ring from the retaining ring holder and
repeat this process for the other retaining rings.
4 Remove the shaving heads from the shaving head holder (Fig. 63).
Throw away the used shaving heads immediately to avoid mixing
them with the new shaving heads.
5 Place the shaving heads in the shaving head holder (Fig. 64).
Note: Make sure the notches on both sides of the shaving heads fit
exactly onto the projections in the shaving head holder.
6 Place the retaining ring holder on the retaining ring (1), place it on
the shaving head (2) and turn it clockwise (3) to reattach the
retaining ring (Fig. 65). Repeat this process for the other retaining
rings.