Pelgrim OWA490RVS Notice D'utilisation page 10

GB
USING THE OWA 600/900 AND
WA 68
Control switches
Fig. 4
A = general switch
B = light switch
C = speed decrease switch
D = speed increase switch
E = display
Installation
When the hood is first switched
on it runs through a phase of
reset and self-cheking. At the end
of this phase a stand-by phase
will be reached: motor and
lamps will be switched off and
the display will show its lower seg-
ment.
Switching on the hood
Switch on the hood by pressing
switch A. The motor will not run
and the display will show 0. You
will set the motor in motion by
pressing switch D, the display will
show 1.
Change speed by using switches
C and D: by pressing either of
them the speed is immediatly
changed by one step.
Continuous pressure on C and D
at the same time for more than 2
seconds causes the motor to
work at its highest speed for 4
minutes. The display shows 9.
After that the hood will return to
the stand-by mode.
Switching off
Pressing switch A turns the motor
off and the hood will return to its
stand-by mode. When the hood
is switched on again the motor
resumes operation at the speed
previously selected.
Using the hood in recirculation
mode
After resetting, the motor speed is
set for use in the exhaust mode.
In order to select the recirculation
mode one of the following steps
must be taken: pressing switch D
in the stand-by mode shows "A"
on the display. This stands for
selection of the exhaust mode.
Pressing switch C and D at the
same time, while on stand-by,
changes operation to recircula-
tion mode. The display shows "F".
Any further pressing of C and D
switches will select the exhaust
mode of operation.
Cleaning/replacing filters
After cleaning the grease filter
the bookmark "G" on the display
will disappear by pressing switch
C for more then 10 seconds. After
replacing the carbon filter the
bookmark "C" on the display will
disappear by pressing switch D
for more then 10 seconds.
ORDERING FILTERS
As with any kitchen appliance,
correct maintenance is
important for the durability of the
cooker hood. If your
extractor hood is fitted with a
fibre filter, this can be replaced
by a was-hable aluminium filter.
This aluminium filter will be sent to
you when ordered in writing or by
telephone.
Ordering accessories
type WA/OWA 10 200
MWA 100 48
51
carbon filter KF 20
aluminium filter AV20 AV 20 *
chimney - -
* supplied
GB
49 50 52 68
490 92 900
59 600
KF49 KF20 KF68
AV20 * *
TP49 - TP49 TP68