Dishwasher Control Section - Kenmore ULTRA WASH 665.1320 Série Guide D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

Sani Rinse

This high temperature option sanitizes your dishes

and glassware in accordance with National

Sanitation Foundation (NSF)/ANSI Standard 184

for Residential Dishwashers. Certified residential

dishwashers are not intended for licensed food

establishments. The word Sanitized will light at the

end of the cycle when successfully completed. If

Sanitization is not achieved (most often due to

cycle interruption) the word Sanitized will flash.

Turbo Heat Dry

Turns the heat element and fan on after the wash

portion of the cycle is over. The fan may remain on

after the overall cycle is complete for a period of

time or until the door is opened. Use rinse aid with

or without the Turbo Heat Dry option for best

drying results. Plastic items are less likely to

deform when loaded in the top dish rack.

*The maximum additional water used for any combination of options is 4.8 gal. (18.2 L).

Delay Hours (on some models)

Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours

when possible. Delay displays how many hours Before the cycle will begin.

To delay the start

1. Select a wash cycle and options.

2. Press the delay button. Each time you press the DELAY button it will display the next available delay time.

NOTE: The dishwasher remembers the last Delay you selected. To reset the delay time to something other than what is displayed

continue to press the Delay button until the desired delay time is reached.

3. Press START/RESUME to begin the delay countdown.

NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again to resume the delay

countdown.

Control Lock Option

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the Lock indicator is lit, all buttons

are disabled. The dishwasher door can still be opened or closed while the controls are locked.

To turn on the Lock

Press and hold SANI RINSE for 3 seconds. The Lock indicator will light up. If you press any pad while your dishwasher is locked, the

light flashes 3 times.

NOTE: The dishwasher cannot start if the control is locked.

To turn off the Lock

Press and hold SANI RINSE for 3 seconds. The light turns off.

Raises the main wash

H E

SmartWash

temperature to 135°F

Pots & Pans

(57°C) and the final rinse

temperature to 156°F

Normal Wash

(69°C).

Available with

Turns the heat element and

any cycle

the fan on at the end of

the wash portion of the

except

cycle.

Quick Rinse