Dishwasher Control Section - Kenmore ULTRA WASH 665.1241 Séries Guide D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

Options

High Temp

Raises main wash temperature to improve cleaning

for loads containing tough, baked-on food.

Sani Rinse

Certified to Sanitize pursuant to NSF/ANSI

Standard 184 for Residential Dishwashers.

Certified residential dishwashers are not intended

for licensed food establishments. Only sanitizing

cycles have been designed to meet the NSF/ANSI

184 performance requirements for soil removal

and sanitization efficacy. **

The Sani Rinse indicator indicates at the end of

the cycle whether the Sani Rinse option was

successfully completed. If the indicator does not

activate, it is probably due to the cycle

being interrupted.

Heated Dry

Turns the heat element on after the wash portion of

the cycle is over. Use rinse aid with or without the

Heated Dry option for best drying results. Plastic

items are less likely to deform when loaded in the

top dish rack.

*The maximum additional water used for any combination of options is 4.8 gal. (18.2 L).

**There is no intention, either directly or indirectly, that all cycles on a certified dishwasher meet the NSF/ANSI 184

performance standard.

Delay Hours (on some models)

Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours

when possible. Delay displays how many hours Before the cycle will begin.

To delay the start

1. Select a wash cycle and options.

2. Press the delay button. Each time you press the DELAY button it will display the next available delay time.

3. Press START/RESUME to begin the delay countdown.

NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again to resume the

delay countdown.

Control Lock Option

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the Lock indicator is lit, all buttons

are disabled. The dishwasher door can still be opened or closed while the controls are locked.

To turn on the Lock

Press and hold SANI RINSE for 3 seconds. The Lock indicator will light up. If you press any pad while your dishwasher is locked, the

light flashes 3 times.

NOTE: The dishwasher cannot start if the control is locked.

To turn off the Lock

Press and hold SANI RINSE for 3 seconds. The light turns off

Can be selected

with

SmartWash

H E

Raises the main wash

Pots & Pans

temperature to 135°F

(57°C).

Normal Wash

Raises the main wash

H E

SmartWash

temperature to 135°F

Pots & Pans

(57°C) and the final

rinse temperature

Normal Wash

to 156°F (69°C).

Available with

Turns the heat element on

any cycle

at the end of the wash

except

portion of the cycle.

Quick Rinse