Dishwasher Control Section; Dishwasher Feedback Section; Canceling A Cycle; Changing A Cycle After Dishwasher Is Started - Kenmore 665.1715 Guide D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

Sani Rinse

This high temperature option sanitizes your

dishes and glassware in accordance with

NSF International NSF/ANSI Standard 184

for Residential Dishwashers. Certified

residential dishwashers are not intended

for licensed food establishments. Only

sanitizing cycles have been designed to

meet the requirements of the NSF/ANSI

184 performance standard for soil removal

and sanitization efficacy. There is no

intention, either directly or indirectly, that

all cycles on a NSF/ANSI 184 certified

dishwasher meet the NSF/ANSI 184

performance standard for soil removal and

sanitization efficacy. The Sani indicator

indicates at the end of the cycle whether

the Sani Rinse option was successfully

completed. If the indicator does not

activate, it is probably due to the cycle

being interrupted.

The maximum additional water used for any combination of options is 2.6 gal. (10.0 L).

†

Control Lock Option

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all buttons are

disabled. The dishwasher door can still be opened/closed while the controls are locked.

To turn on the Lock

Press and hold HEATED DRY for 3 seconds. LOCK ON will light up. If you press any pad while your dishwasher is locked, the light

flashes 3 times.

NOTE: The dishwasher cannot start if the control is locked.

To turn off the Lock

Press and hold HEATED DRY for 3 seconds. The light turns off.

Selecting Cycles and Options

1. Select the desired cycle. If you want to run the last cycle that was completed, you can simply press START once to show which

options you used, then press START again to start the cycle.

2. Select the desired options. Not all options are available for every cycle.

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.

2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.

3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the

dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.

You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.

2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before

restarting your new cycle.

3. Press CANCEL/DRAIN twice to reset the control.

4. Select new cycles and options.

5. Press START/RESUME.

Pots & Pans

Normal Wash