Checking For Blockages; Nozzle Maintenance - shark VERTEX l DuoClean PowerFins Powered Lift-Away AZ2000 Série Guide De L'utilisateur

MAINTENANCE

NOZZLE MAINTENANCE

SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, clear them from the
brushroll.
CLEANING THE SOFT ROLLER
Slide the Soft Roller access button forward to
release the Soft Roller.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed. Use only
water, and allow it to air-dry completely for at
least 24 hours. Reinsert the Soft Roller in the
front of the nozzle until it clicks into place.

CHECKING FOR BLOCKAGES

HOSE BLOCKAGE
Detach hose from vacuum pod, and check
hose and opening on back of pod for
blockages.
POD BLOCKAGE
Detach wand from floor nozzle, tilt nozzle
neck back, and check opening for blockages.
NOZZLE HOSE BLOCKAGE
To access the nozzle hose, open the locks
on the bottom of the nozzle. With a coin,
turn the locks counterclockwise, then lift the
cover and clear any blockages.
WAND BLOCKAGE
Detach wand from floor nozzle and handle,
and check both ends for blockages.
HANDLE/HOSE BLOCKAGE
Detach handle from wand and hose from
the vacuum pod, and check openings for
blockages.
s h a r kc l e a n . c o m