Cleaning The Brush-Roll; Cleaning The Soft Roller; Checking The Nozzle For Blockages - shark NZ801EUT Mode D'emploi

MAINTENANCE – CONT�
Anti-Hair Wrap Technology
TIP: You can also
check for blockages
Anti-Hair Wrap Technology actively removes hair wrap
in the hose and
from your brush-roll while you vacuum. If you run over
airways. Just remove
a hard or sharp object or notice a noise change while
the floor nozzle,
vacuuming, check for blockages or objects caught in
dust cup, and hose
the brush-roll.
and shine a torch
in the openings. NOTE: Do not be alarmed if there is visible hair at any given
time, as it will eventually make its way to the dust cup.
If you see any hair
wrapped around the
brush-roll, continue
cleaning, using
Carpet/Low Pile
mode on hard floors.
This will allow
Anti-Hair Wrap
technology to
remove the hair
wrap and send it to
the dust cup.

CLEANING THE BRUSH-ROLL

1
Use a coin to unlock the 3 locks on the bottom of
the floor nozzle, a portion of the base is removable
to allow for better access to the brush roll and
exposure to the airway. Shine a torch from the
bottom to check for possible blockage in the airway.
2 Clear away any objects or debris.
3 To reassemble, replace base by lining it up along the
front of the nozzle. Push down to snap into place.
Lock the 3 locks.
17
s h a r kc l e a n . e u
STEP 1
DuoClean Technology
DuoClean Technology features a bristle brush to
deep-clean carpets, and an additional soft brush-roll
to pull in larger particles and directly engage floors
for a polished look. With normal use, you may need
to perform routine maintenance of your Soft Roller.
See the instructions below.

CLEANING THE SOFT ROLLER

1 To remove Soft Roller from nozzle, lift
it out pulling the tab on the right side.
2 Tap loose debris off the Soft Roller.
Use a dry towel to wipe the Soft
Roller clean, or to remove any
debris caught in the teeth behind
the Soft Roller.
3 Hand-wash the Soft Roller as needed.
Use only water, and let air-dry
completely for at least 24 hours.
4 Reinsert Soft Roller under rubber
bumper in front of nozzle until it
clicks into place.

CHECKING THE NOZZLE FOR BLOCKAGES

1
Tilt neck of nozzle back to straighten
the airway, then remove any
blockages.
s h a r kc l e a n . e u
18