Cleaning And Maintenance - Perel EWL311 Mode D'emploi

EWL311 (CW-R/NW-R)/EWL312 (CW-R/NW-R)
6. Operation
Charging
The EWL311xW-R/EWL312xW-R is a battery-operated floodlight that needs
to be charged before first use. Proceed as follows:
1. Make sure to switch off the floodlight first by placing the on-off
button [3] on 0.
2. Insert the plug from the charger into the charger input [4].
3. Insert the charger into the mains.
Important note:
The floodlight MUST be switched off before and during charging!
Use
1. Place the floodlight on a suitable location.
2. Switch on the floodlight with the on-off button [3] and choose the
power rate (I: half power, II: full power).
3. Switch off after use.
Mounting bracket
1. Slightly loosen the fixing knob [1].
2. Adjust the mounting bracket [2] as desired.
3. Re-tighten the fixing knob [1].

7. Cleaning and Maintenance

 All screws should be tight and free of corrosion.
 The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not be
deformed, modified or tampered with; e.g. do not drill extra holes in
mounting supports, do not change the location of the connections...
 Mechanically moving parts must not show any signs of wear and tear.
 If the protective glass is damaged, have it repaired immediately by a
qualified technician. Do not use the lamp with a cracked or broken
protective glass.
 Wipe the device regularly with a moist, lint-free cloth. Do not use
alcohol or solvents.
 There are no user-serviceable parts.
 Contact your dealer for spare parts if necessary.
V. 01 – 22/07/2014 5 ©Velleman nv