Cleaning And Maintenance; Technical Specifications - Perel LEDA500xNW-BM Mode D'emploi

Switch off.
Time
Next, select the time setting.
1. Press the daylight or nightlight mode button to activate the floodlight sensor.
2. Select the desired time by pressing the corresponding time button. The floodlight will flash once to
confirm the setting. When triggered, the floodlight will switch on for the programmed time.
Sensitivity
Finally, select the sensitivity setting.
Remote control response sensitivity.
100 %: 7-8 m; 75 %: 5-6 m; 50 %: 3-4 m; 25 %: 1-2 m.
1. Press the daylight or nightlight mode button to activate the floodlight sensor.
2. Select the desired sensitivity by pressing the corresponding sensitivity button. The floodlight will
flash once to confirm the setting.
7.

Cleaning and Maintenance

•
This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
•
All screws should be tight and free of corrosion.
•
The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the connections...
•
The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
•
If the protective glass is damaged, disconnect the lamp immediately from the mains. Have it repaired
immediately by a qualified technician. Do not use the lamp with a cracked or broken protective glass.
•
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
•
There are no user-serviceable parts.
•
Contact your dealer for spare parts if necessary.
8.

Technical Specifications

body colour
electrical data
power LED module
total nominal power
nominal voltage driver
power factor
energy consumption
light technical data
colour
colour temperature
beam angle
luminous flux
colour rendering index
starting time
warm-up time (60 %)
V. 03 – 03/04/2020
LEDA500xNW-BM
LEDA5001NW-BM
10 W COB
10 W
220-240 VAC
0.57
10 kWh/1000 h
neutral white
750 lm
6
LEDA5002NW-BM
black
20 W COB
20 W
0.8
20 kWh/1000 h
4000 K
120°
1600 lm
> 75
< 0.5 s
< 1 s
©Velleman nv