Technical Specifications - BoomToneDJ ColorPix Mode D'emploi


To prevent or reduce the risk of electrical shock or fire, do not expose the fixture
to rain or moisture.

Do not look directly at the LED light beam while the fixture is on.

Do not touch any wire during operation.

The unit should be mounted via its screw holes on the bracket. Always ensure
that the unit is firmly fixed to avoid vibration and slipping while operating.
Always ensure that the structure to which you are attaching the unit is secure
and is able to support a weight of 10 times of the unit's weight. Also always use
a safety cable that can hold 12 times of the weight of the unit when installing
the fixture.

The equipment must be fixed by professionals. And it must be fixed at a place
where is out of the touch of people and has no one pass by or under it.
Note:

2- Technical Specifications


Power supply：AC100-240V 50/60Hz

Fuse：F3A/250V

Power Supply：IEC Input/output block

Light source：24 X 3 Watt 3 in 1 LEDS, RGB

Beam Angle: 45 degrees

8 groups of 3 LED independently controlable

DMX Channels：5/8/14/26 or 50 DMX channels selectable

Packing Dimensions ：L 1000 × l +65 × H65mm

Gross Weight：3 kg
(1)In ten seconds, if no buttons to press, the LED display will be off.
Press any button to turn the display on again.
(2)After pressing a button, all the parameters will save automatically
after 2 seconds.
(3)No matter the item is in which program in which mode, once
detecting DMX or SLAVE signal, the program will jump into
DMX or SLAVE mode automatically. Then,if DMX/SLAVE
signal off, the program will return to the original mode .
11