Wolf SEM-2 Instructions De Montage page 10

Table of contents
Safety instructions
Solar tank SEM-2
Note
10
Safety instructions /
Short description
Safety instructions and short description ....................................................................10
Technical data.............................................................................................................11
Pipework .....................................................................................................................12
Installation / assembly ................................................................................................13
Controller for charging pump .....................................................................................14
Start-up - Servicing .....................................................................................................15
Flow resistances .........................................................................................................16
The following symbols and signs are used in this description. These important
instructions concern personal safety and technical reliability.
"Safety instructions" identify instructions with which you must exactly comply
to prevent injury and damage to the equipment.
Danger through 'live' electrical components.
Warning: Switch the ON/OFF switch to OFF before removing the casing.
Never touch electrical components or contacts when the ON/OFF switch is in
the ON position. This brings a risk of electrocution, which may result in injury
or death.
The supply terminals are still "live" even when the ON/OFF switch is OFF.
"Information" identifies technical instructions which you must observe to prevent
Warning
damage and avoid malfunctions.
Solar tank type SEM-2 made of steel S235JR with quality certification (with lateral flange).
Corrosion protection by double coat enamelling of the inner surface of the tank and heater
coil in accordance with DIN 4753, part 3. Additional corrosion protection with magnesium
protective anode. Can be used with all water conditions and in any pipe system.
The solar pump assembly from the Wolf range can be optionally mounted directly to
the solar tank SEM-2 with the assistance of a solar connection set.
By operating the tank below 60°C, substantial energy savings can be achieved.
Ideal operating temperatures are between 50-60°C.
Heat loss and calcification is substantially reduced in this range.
3062505_201312