Combustion Pace; Assembly - Nordpeis Salzburg L Basic Manuel D'installation

Attention! Failure to follow the guidelines for drying
can cause the elements to crack.
The air vent control is turned to the right to increase
the air supply to Salzburg L basic
-
+

Combustion pace

An accumulating fireplace is designed to absorb
thermal energy during a relatively short period of
relatively intense heat. When the period of intensive
combustion is completed, the product will deliver the
accumulated heat over a longer period of time.
Attention! Combustion beyond the recommended
pace (see table with Technical Information) will
result in a higher surface temperatures, which can
lead to discoloration of the paint. It can also result
in higher than intended temperatures against com-
bustible walls.
Follow the values in the table to find the correct load
size and what loading interval is right for your product.
When the last load has passed into the ember phase
with few embers left, the air vent and damper is closed
to prevent heat escaping through the chimney.
Remember to open the damper before making a fire in
the fireplace.
The ignition mode should only be open during when
necessary for short periods (10-15 minutes) at the time
a fire is lit, and at new loads, in order to prevent smoke
or ash escaping into the room. Persistent combustion
with an open ignition mode can result in exceeding the
maximum allowed chimney temperature.
Due to the length of the smoke gas ducts, the
fireplace is heated up somewhat unevenly. After
lighting a fire, the front above the door and one of
the sides will heat up first. The heat will then be
evened out after a few hours of burning and when
all the ducts have been warmed up.
6. Assembly, see page 32
Attention! It is very important that installation in-
structions are read carefully and followed closely in
order to ensure optimal functioning of the product.
GB
8