Elem Garden Technic SEBRTH18VLI Traduction Des Instructions D'origine page 55

Align the button with the hole in the housing.
Rotating the hedger trimmer cutting head in to the housing until the hook clicks in to place。 。 。 。
Tighten the screw securely。 。 。 。 And then rotating the handle to the comfortable position by press
the locking knob(34)
Note:
If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate
from side to side until the button is locked into place。
Adjusting the cutting angel.
Cutting tips for Hedge trimmer.
1. Assume a secure position, using two hands to hold the trimmer and switch on.
2. Trim both sides of the hedge, starting at the bottom. This prevents cuttings falling into the area yet to be cut.
3. Pass the blade lightly through the surface of the hedge. Do not attempt to cut too deep.
4. Trim the top of the hedge.
5. For older hedges that require cutting back substantially, use pruning shears to cut the thicker branches and
then finish the job with the hedge trimmer.
6. Never use the hedge trimmer without check the tightness of the bracket。
TROUBLESHOOTING
Warning:Unplug the Chain saw before any maintenance.Eledtrical shock or a contact with the rotating chain
might cause severe injuries or fatal accidents.
Page 55 de 64
1> Press the rotating knob.
2> Adjusting the cutting head to a comfortable position.
3> Release the knob.