Fit The Belly Strap; Fit The Chest Strap - Petsafe easy walk Manuel De Montage

STEP 2

Fit the Belly Strap

1. Tighten the shoulder strap to a
comfortably snug fi t, allowing for just a
fi nger's width underneath. The snug fi t
is required because the girth creates the
"foundation" that keeps the harness in
place (2A).
2. When the girth (shoulder and belly straps
combined) is fi tted correctly, it should
resemble a vertical line.
STEP 3

Fit the Chest Strap

1. After you have the girth properly secured, begin to fi t the chest strap. Gently press fi ngers
on lower front of dog's chest to locate the breastbone (3A).
2. Adjust each portion of the chest strap equally to keep the D-ring centered (3B).
3A
6
www.petsafe.net
2A
3B
3. When adjusted correctly, the chest strap will be horizontal, resting over the dog's
breastbone. It should sit nearly parallel to the ground and should not "hang down" or
gap (3C).
4. Attach the 1.8 nylon lead to the D-ring on the chest strap (3D).
3C
You may need to remove the harness during fitting to make these adjustments.
Tip
Also, dogs may "tense up" during fitting, so check the fit again after the dog has
walked in the harness for a few minutes.
D-Ring
Chest Strap
www.petsafe.net
Shoulder Strap
Connector Ring
Belly
The Perfect Fit!
Strap
3D
7