Machine Control Panel C28, C33 - Clarke FOGUS C28 Manuel De L'utilisateur

ENGLISH
EN

MACHINE CONTROL PANEL C28, C33

Key Switch (See Figure #1, Item "A")
The key switch turns "ON" the power to the control panel. "0" is "OFF" and "I" is "ON".
Traverse Speed Switch (See Figure #1, Item "B")
The speed control varies from low to high speed. To increase the speed, turn the knob to the right. To decrease the
speed, turn the knob to the left.
Brush Up/Down Switch (See Figure #1, Item "C")
The brush switch has two positions: "Up" positions the brushes up; "Down" positions the brushes on the floor. The
brush motors start when the brushes are down and the traverse switch is depressed.
Solution Control Knob (See Figure #1, Item "D")
The solution control knob regulates the flow of cleaning solution to the floor. To increase the flow turn the knob
clockwise. To decrease the flow, turn the knob counter-clockwise.
Forward Switch (See Figure #1, Item "E")
The forward switch turns the traverse motor "on" and if the brush motors are in the down position, it also activates the
brush motors and solution control module. Either the right or the left switch can be used.
Reverse Switch (See Figure #1, Item "F")
The reverse switch, when used in conjunction with one of the forward switches, causes the machine to reverse
direction. The reverse speed is 70% of the forward speed.
Charge / Battery Meter (See Figure #1, Item "G")
The charge/battery meter indicates the battery is being charged when the charger is plugged into an AC outlet. It also
indicates the amount of charge that is left in the batteries while the machine is in use. When the battery charger gets
too low the red light will begin flashing and the brush/pad motors will shut off.
Circuit Breakers (See Figure #1, Item "H"-"L")
The circuit breaker reset buttons are located on the control panel. The breakers are located as follows:
Brush Motors (40A); Item J - Traverse Motor (30A); Item K - Vac Motor (25A); Item L - Actuator Motor, Brush Head (5A)
If a circuit breaker trips, determine which motor is not operating and turn the key switch "OFF". Wait five minutes and
push the reset button back in. Turn the key switch "ON", and try again. An authorized service person should be
contacted if the breaker trips again.
Hour Meter (See Figure #1, Item "M")
The hour meter indicates the number of hours the machine has operated. It runs only when the machine is moving
forward or reverse.
Page -8-
®
Clarke
Operator's Manual (EN) - FOCUS C28 and C33
Item H & I -