Preparing The Appliance - Krups LATT'ESPRESS EA829 Mode D'emploi

Preparing the appliance

Remove the lid of the coffee container and add coffee beans. Replace the lid (9-10).
the "min" level) while the appliance is switched on, the message "Fill tank" will appear and it will be temporarily impossible
to make any coffee or espresso.
Claris - Aqua Filter System F 088 cartridge (sold separately)
Filter System cartridge, sold separately.
(3):
Your appliance will let you know when you should replace your Claris - Aqua Filter System cartridge by displaying a message.
Filter installation (Claris - Aqua Filter System cartridge)
Note: To correctly prime your cartridge, ensure that you follow the installation procedure each time you change the cartridge.
First time use: Choose the "YES" option in the "Filter" function, then follow the on-screen prompts.
Insert the steam nozzle (5).
Place a 0.6 L container beneath the steam nozzle (6).
- "Insert" (or change) - OK - and follow the on-screen prompts.
Automatic rinsing
"Auto rinse" menu. Rinsing will take place each time you turn on the machine.
To modify this at a later stage, you can select automatic rinsing by pressing PROG – Settings - Auto rinse.
DURING RINSING OPERATIONS, HOT WATER COMES FROM THE NOZZLES. BE CAREFUL NOT TO SCALD YOURSELF.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER
the machine.
Make sure that no foreign bodies such as small stones among the coffee beans enter the coffee container. Any damage due to
foreign bodies having entered the coffee container is not covered by the guarantee. Do not put water in the coffee bean container.
To avoid staining your worktop or scalding yourself with used water, ensure you attach the drip collector tray.
Check the water tank is clean.
First use/setting the machine
Switch the appliance on by pressing the "On/Off" button (11). Follow the on-screen prompts in the "Language choice" menu.
Select a language using the rotating button. The selected language will be highlighted (12-13).
some of these parameters.
The appliance will ask you to set:
Language
Volume unit
Date
Clock
Auto-off
Auto-on
Water hardness
Automatic rinsing
Filter
22
(7).
(8).
Select the "Filter" menu by pressing PROG: "Maintenance" - OK - "Filter"- OK
you may choose to activate automatic rinsing. To do this, choose the "YES" option on the
(14).
You can select the language of your choice from those presented.
You can set the unit of measurement to ml or oz.
It is up to you to set the date.
You can select the display of a 12 or 24-hour clock.
You can select the length of time after which your appliance will switch off automatically.
You can automatically start pre-heating of your appliance at a selected time.
You must set the hardness of your water between 0 and 4. See the section "Measuring the
water hardness".
You can set rinsing to take place each time the machine is switched on.
If the water tank is missing or not completely full (beneath
(4).