Technical Information; Installation Considerations - Hansgrohe AXOR Starck 10942 1 Série Instructions De Montage / Mode D'emploi / Garantie

9½"
4¾"
max. 16.5 lb
(7.5 Kg)
2⁷⁄₁₆" 4⁹⁄₁₆"
Tools Required / Outiles Utiles /
Herramientas Útiles
2 mm
2.5 mm
2
4¾"
2⁷⁄₁₆"
7"
7⅛"
⅜"
17 mm
10 mm
13 mm
English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate @ 44 PSI
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• A sediment filter is installed on this unit. Do not
remove the filter permanently. Damage to or
clogging of the tub spout caused by sediment is
not covered by the Hansgrohe warranty.
• To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum out-
put temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
4.5 GPM