Assembly - Parkside PWD 20 A1 Instructions D'origine

GB IE
pulled over sharp edges, be-
coming trapped or by pulling
on the line.
• Never use the power line to pull
the plug out of the socket or to
pull the appliance. Protect the
power line from heat, oil and
sharp edges.
• Switch the appliance off and
unplug the power chord:
- when you are not using the
device or when you are
transporting or leaving it un-
attended;
- when you inspect the ma-
chine, clean it or remove
blockages;
- when you perform cleaning
or maintenance work, or
swap accessories;
- if the connection cable is
damaged or entangled,
- after contact with foreign
bodies or if abnormal vibra-
tion occurs.
• If the mains connection cable
of this appliance is damaged,
it must be replaced by the
manufacturer or their customer
service or by a similarly quali-
fied person in order to avoid
hazards.
This is how to avoid damage
to the appliance and possi-
ble personal injuries result-
ing from this:
• Make sure before use that the
appliance is properly assem-
bled and that the filters are in
the correct position.
• Do not perform vacuuming
without filters. The device could
become damaged.
20
• Only use original spare parts
and accessories (see "Spare
Parts/Accessories"), which are
supplied and recommended by
our service centre. Using exter-
nally produced parts results in
the immediate loss of the war-
ranty claim.
• Only have repairs performed by
customer service centres author-
ised by us.
• Comply with the appliance's
cleaning and maintenance in-
structions.
• Store the device in a dry place
and out of reach of children.

Assembly

NOTE! The appliance is delivered with a
motor head (1) attached. To remove the
motor head, open the fastening clips (8).
1. Remove the mains plug.
2. Place the feet (7) into the receptors on
the dirt container (6).
3. Insert the desired filter if it is not pre-
mounted:
- Foam filter for wet suction (
- Textile filter bag (
suction,
- Paper filter bag (
Never perform vacuuming with-
out a filter!
4. After changing filter: Place the motor
head (1) onto the dirt container (6) and
lock it into place using the fastening
clips (8).
5. Attach the suction hose (13) and acces-
sories.
15),
16) for dry
17).