Tips On Saving Energy; Service Programme - Siemens TE501 Série Mode D'emploi

en

Tips on saving energy

Tips on saving energy
■ Switch off the fully automatic espresso
machine when not in use. To do this,
press the service button (12). The
a ppliance rinses and switches off.
■ If possible, do not interrupt coffee
or milk froth dispensing. Stopping a
process prematurely results in higher
energy consumption and the drip tray
fills up more quickly.
■ Descale the appliance regularly
to avoid a build-up of limescale.
L imescale residue results in higher
energy consumption.

Service programme

Duration: approx. 35 minutes
Depending on use, the service button (12)
flashes at certain intervals.
The appliance should be cleaned and
descaled immediately using the service
programme. If the service programme is
not run as instructed, the appliance may
be damaged.
W Caution!
Follow the instructions for using the
descaling and cleaning agents for each
service programme. Please observe the
safety instructions on the packaging of the
cleaning agent.
Never interrupt the service programme.
Do not drink the liquids.
Never use vinegar, vinegar-based products,
citric acid or citric acid-based products.
Never put descaling tablets or other
d escaling agents in the drawer (4).
Prior to starting the service programme,
remove the brewing unit, clean as
instructed and re-insert.
Specially developed and suitable
descaling and cleaning tablets are
available from retailers or customer
service (see "Accessories").
14
Important: If there is a water filter in the
water tank (16), it must be removed before
starting the service programme. Clean the
brewing unit before starting the service
programme, see chapter "Cleaning the
brewing unit".
To start the service programme, press and
hold the service button (12) for at least
5 seconds.
Information: The service button (12)
fl ashes while the programme is running.
H
LED lights up.
■ Empty the drip tray (8) and reinsert it.
G
LED lights up.
■ Open the drawer (4).
■ Drop a Siemens cleaning tablet into
the drawer (4) and close it.
■ Press the start button (10).
D
LED lights up.
■ Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark
and then dissolve 1 Siemens descaling
tablet TZ80002 in it.
■ Press the start button (10).
The service programme will now run for
a pproximately 10 minutes.
F
LED lights up.
■ Place a container with a capacity of at
least 0.5 litres under the milk frother
o utlet (6).
■ Pull out the milk frother (6) to open it.
The service programme will now run for
a pproximately 12 minutes.
D
LED lights up.
■ Rinse the water tank (16) and refill it
with fresh water up to the max mark.
■ Press the start button (10).