Moen nebia Guide D'installation page 4

COMPATIBILITY REQUIREMENTS
A
Min 4"
Min 5"
C
C
Min 5"
AREA
B MUST BE
CLEAR
Min 29"
Trim/temperature
controls not included.
Visit moen.com/nebia for tips and videos.
To install Nebia by Moen, you will need:
WATER HEATER TEMPERATURE
of at least 115°F/46°C
WATER PRESSURE
of at least 20psi/1.4bar
SPACING
The water outlet must be in a wall
•
(not the ceiling).
The recommended floor to water
•
outlet distance is 72"-84"(183-213cm).
The minimum clearance from water
•
outlet to ceiling is 4" (10cm) (
Make sure there is 29" (74cm) (
•
space between your shower arm and the
top of the trim/temperature controls.
The minumum clearance from nearest
•
side wall is 5" (13cm) ( C ).
OTHER
Your wall must have a ½" NPT (or ½"
•
BSPT) pipe connection (this is standard
in most bathrooms).
The wall surface cannot be slate.
•
PREPARING FOR INSTALL
STEP 1:
Unscrew and remove your old shower arm
and showerhead from the wall by turning
counterclockwise.* With Nebia by Moen,
you'll no longer need it.
Then, remove the trim/escutcheon from the
wall. Before installing your new product, clean
all walls and surfaces.
* If needed, this may be the only step where you use vise grips
or a wrench.
Trim/Escutcheon
A
).
B
) of clear
Shower Arm
Shower Head
3