How To Operate - ARIETE 2765 Mode D'emploi

Fully discharge the battery before a new recharge.
The recharge light (D) starting blinking quickly signals a failure on the recharge circuit.
Contact an authorized Service Centre Ariete.
The adapter (I) and the base upper part (H) may warm up during recharge; this is normal.
Avoid to recharge at a temperature below 5°C (40°F) or above 40°C (105°F) to prevent dama-
ges of batteries.
If the appliance does not work, check it is properly inserted in its recharging base (G), is
powered and correctly plugged in.
ATTACHMENTS
Brush for floors / carpets (O)
Suitable for cleaning any kind of surfaces, including carpets.
- Insert the brush into the appliance body (R), by slightly pressing is until it locks in place (Fig. 7).
- Take the brush outwards to remove it.
Vacuum cleaner with brush (Q) - for handheld vacuum cleaner only
Suitable for cleaning surfaces and working tables, as well as couches and fabrics.
Crevice nozzle (P) - for handheld vacuum cleaner only
Suitable for cleaning corners, crevices or areas hard to reach.

HOW TO OPERATE

- Before using the appliance, make sure the battery is fully charged.
- With the handheld part (F) properly assembled in the appliance body (R), press the switching on
button (T) and tilt the handle backwards in the standard position of use.
- Clean the wide surfaces by pushing with the brush (O) forwards.
This allows the vacuum cleaner to collect the fragments and the dirt on the floor.
- For cleaning the corners and small surfaces, rotate the broom in the opposite direction. The frag-
ments and dirt can be moved to be collected.
ATTENTION: switch the broom off immediately when something remains stuck inside the brush, as
some fabric, carpet fringes, etc.
- After cleaning, switch the broom off by pressing the switching off button (T) once more.
Handheld vacuum cleaner
- By holding the handle of the appliance body (R), simultaneously press the unlocking buttons (C)
and remove the handheld vacuum cleaner (F) - Fig. 8.
- At the end of the dust container (F), apply the required attachment (Fig. 9); press the switching on
button (D) to start the appliance by means of the apposite handle (E) - Fig. 10.
- For positioning the handheld vacuum cleaner back into the appliance body (R), remove the
- 11 -
EN