Automatic Preset Tuning; Exchanging Preset Stations - Yamaha RX-77 Mode D'emploi

AUTOMATIC PRESET TUNING

You can make use of an automatic preset tuning function for FM stations. With this function, this unit performs automatic
tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as
in the manual preset tuning method on page 14.
NATURAL SOUND STEREO RECEIVER RX–777
STANDBY/ON
A/B/C/D/E 1 2 3 4 5 6
BASS TREBLE BALANCE
PHONES SPEAKERS
0 0
1 1 1 1 1
A B
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
— 5 5 — — 5 5 — L 5
To store stations
1
FM/AM
2
MEMORY
MAN'L/AUTO FM
Press and hold for more
than 3 seconds.
3
DOWN
To tune to higher frequencies, press right side once.
To tune to lower frequencies, press left side once.
* If the TUNING button is not pressed, in a while, the
automatic preset tuning begins automatically toward
higher frequencies.
The automatic preset tuning begins from the frequency
currently displayed. Received stations are programmed
to A1, A2 ... A8 sequentially.
* If more than 8 stations are received, they are also
programmed to the preset station numbers of other
groups (B, C, D and E) in that order.
If you want to store the first station received by the
automatic preset tuning to a desired preset station
number;
If, for example, you want to store the first received station to
C5, select "C5" by using the A/B/C/D/E button and the
PRESET STATIONS buttons after pressing the MEMORY
button in step 2. Then press the TUNING button. The first
received station is stored to C5, and next stations to C6, C7
... sequentially.
If stations are stored up to E8, the automatic preset tuning is
finished automatically.
2 3 1
PURE CD DIRECT
DOWN TUNING UP DIRECT AMP
MEMORY EDIT FM/AM
MAN'L/AUTO FM
INPUT VOLUME 16
20 12
7 8
TUNING MODE REC OUT/ZONE 2 VCR · D-TV · DVD · TAPE/MD · TUNER · CD · PHONO
TUNER
28 8
TAPE/MD CD
AUTO/MAN'L MONO
DVD PHONO
D-TV 40 4
LOUDNESS
0 FLAT VCR
1 1
-30%
2 2 10 60 2
3 3 9 ∞
0
4 4 8 –dB
5 R 5 7
6
MEMO
Flashes.
TUNING
UP
When the automatic preset tuning is finished;
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on page 14.
Notes
• You can replace a preset station by another FM or AM station
manually by simply following the procedure of the section "To
store stations" on page 14.
• If the number of received stations is not enough to be stored up
to E8, the search is finished automatically after searching all
frequencies.
• With this function, only FM stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 14.
• For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.

EXCHANGING PRESET STATIONS

You can exchange the places of two preset stations with
each other as shown below.
Example)
If you want to shift the preset station on E1 to A5.
1 Recall the preset station on E1 (by following the
method of "To recall a preset station" on page 14).
2
EDIT
3 Recall the preset station on A5 by following the
same method as in step 1.
4
EDIT
TUNING OPERATIONS
MEMO
Flashes.
MEMO
Shows the exchange of
stations is completed.
E-15