Battery Installation; Display Panel - Yamaha RX-77 Mode D'emploi

CONTROLS AND THEIR FUNCTIONS

Battery installation

1
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
• Use only AA, R6, UM-3 batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside the
battery compartment.)
• Remove the batteries if the remote control transmitter will not be
used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid touching
the leaked material or letting it come in contact with clothing,
etc. Clean the battery compartment thoroughly before installing
new batteries.

DISPLAY PANEL

MEMO
9
1 Multi-information display
Displays various information, for example station frequency, preset
station number and name of selected input source.
2 AUTO indicator
Lights up when this unit is in the automatic tuning mode.
3 TUNED indicator
Lights up when turned in to a station.
4 STEREO indicator
Lights up when an FM stereo broadcast with sufficient signal
strength is received.
5 CD DIRECT
Lights up when CD DIRECT is on.
E-4
3
2
1
Remote control transmitter
operation range
NATURAL SOUND STEREO RECEIVER RX–777
STANDBY/ON
A/B/C/D/E 1 2 3 4 5
PHONES SPEAKERS BASS TREBLE
0 0
A B 1 1 1
2 2 2
3 3 3
4 4 4
— 5 5 — — 5
Remote control
Notes
• There should be no large obstacles between the remote control
transmitter and the main unit.
• If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.), it
might cause the remote control transmitter not to work correctly.
In this case, reposition the main unit to avoid direct lighting.
2
AUTO
H
K Z
MH
Z
SLEEP
8 7
6 SPEAKERS A B indicator
Lights up according to which set of main speakers is selected. Both
indicators light up when both sets of speakers are selected.
7 SLEEP indicator
Lights up while the built-in SLEEP timer is functioning.
8 PURE DIRECT
Lights up when PURE DIRECT is on.
9 MEMO indicator
When the MEMORY button is pressed, this indicator flashes for
about 5 seconds. While this indicator is flashing, the displayed
station can be programmed to the memory by using the A/B/C/D/E
button and the PRESET STATIONS buttons.
PURE CD DIRECT
DOWN TUNING UP DIRECT AMP
MEMORY EDIT FM/AM
MAN'L/AUTO FM
INPUT VOLUME 16
6 7 8 20 12
TUNING MODE REC OUT/ZONE 2 VCR · D-TV · DVD · TAPE/MD · TUNER · CD · PHONO
TUNER
TAPE/MD CD 28 8
AUTO/MAN'L MONO
DVD PHONO
D-TV 40 4
BALANCE LOUDNESS
0 FLAT VCR
1 1 1 1
-30%
2 2 2 2 10 60 2
3 3 3 3 9
∞
0
4 4 4 4 8 –dB
5 — L 5 5 R 5 7
6
sensor
Within approximately
6 m (19.7 feet)
3 4 5
TUNED
STEREO
PURE CD
DIRECT DIRECT
SPEAKERS
A B
6