Attaching The Belt Clip; Using The Test Light - Dogtra 2600T&B Guide D'utilisation

13. ATTACHING THE BELT CLIP

Follow the instructions below to attach the included belt
clip to the transmitter.
1. Align the belt clip to the grooves on the back of the
transmitter.
2. With a firm grip, screw on the belt clip's Phillips head
screws with a screwdriver.
Caution!
Tighten until firmly in place. Be careful not to over
tighten.
68

14. USING THE TEST LIGHT

1. To turn on the receiver/collar, place the red dot on the
back of the transmitter to the red dot on the receiver/
collar. Hold the two red dots together for a moment
until the LED light on the receiver/collar comes on.
The indicator light will come on for a moment then
blink once every 5 seconds, showing that the collar is
ready to use (the receiver needs to be charged if the
indicator light is red). The receiver/collar will emit a
melody when turned on.
2. Turn the transmitter on by pressing the black button
on the right side of the transmitter until the LCD
screen illuminates. The LED will blink every 5 seconds
and the LCD screen will show the remaining battery
life (the transmitter needs to be charged if there is
only 1 bar showing on the battery icon for the LCD
transmitter screen).
3. Place the test light, included in the package contents,
on the contact points as shown in the picture.
69