General Training Tips - Dogtra 2600T&B Guide D'utilisation

Note 3: In the Run/Point or Point-Only mode the volume
can be changed by holding down the Locate button and
then pressing the Pager button to choose the desired
volume.
Note 4: In the Run/Point or Point-Only mode, it is still
possible to use vibration and electrical stimulation.
* To make sure that your beeper volume is in working
condition, please refer to page 17 for further testing
instructions.
72

GENERAL TRAINING TIPS

Getting Started With Your 2600T&B
Your dog must know some basic obedience commands
before beginning training with the 2600T&B. A dog
learns by first being shown a command, followed by
lots of repetition over an extended period. As the dog
becomes proficient at these commands, the trainer
can introduce distractions and different locations to
strengthen them.
Obedience Training on the Leash
Your dog must fully understand the obedience
commands (sit, stay, here, heel, and kennel) before using
the e-collar for reinforcement of these commands. A
leash attached to a standard collar is used to "teach" the
dog the basic obedience commands (here, heel, sit, and
stay). A tug on the leash/collar is used to reinforce the
command. When the dog complies with the command,
use positive reinforcement/praise. Once the dog
understands these commands, the e-collar can be used
to reinforce them.
73