Finding The Right Stimulation Intensity Selection; Familiarizing The Dog To The Beeper; Maximizing The Distance - Dogtra 2600T&B Guide D'utilisation

Attention!
Leaving the receiver/collar in the same location on
the dog's neck for an extended period of time can
cause skin irritation. If the dog is to wear the e-collar
for more than 6 hours in a row, occasionally
reposition the collar so that the contact points are
moved to a different location on the dog's neck.
Make sure you check for skin irritation each time you
use the unit.
6. FINDING THE RIGHT STIMULATION INTENSITY
SELECTION
The 2600T&B Series has a Rheostat Dial on the top of
the transmitter (0 is the lowest and 127 is the highest).
Remember that you will need to adjust the setting
(upward or downward) depending on your dog's
temperament and threshold for stimulation. Also, as
the dog's attitude changes, especially during times of
increased excitement or distraction, you may need to
adjust the intensity level.
Note: The stimulation intensity can be adjusted even
when the stimulation is in use.
60

7. FAMILIARIZING THE DOG TO THE BEEPER

Turn the beeper collar on and leave it outside the dog's
kennel area for about 30 minutes. Repeat this several
times until you can see that the dog disregards the
beeper. Next, adjust the beeper volume level to level
L1 or H1, the lowest level. Fit the beeper collar on the
dog and select the desired beeper volume level as the
dog becomes accustomed to the beeping sound.

8. MAXIMIZING THE DISTANCE

The 2600T&B Series collar has a maximum range of 1600
metres. Depending on where you are and the way you
use your transmitter, the transmitter range may vary.
To get the greatest range, hold the transmitter away
from your body and avoid touching the antenna. Keep
your unit properly charged for maximum signal strength.
Maximum Typical range Minimum range
61