Verco G5 Manuel D'emploi Et D'entretien page 11

E - 72.511 -
INSTALLATION AND MAINTENANCE MANUAL
2008 - GEB0801LG59
Contents
I. Important information
II. Components
III. Dimensions
IV. Installation
V. Commissioning
VI. Maintenance
VII. Troubleshooting
I. IMPORTANT INFORMATION
I.1. Air curtain
Serie G5 : warm air curtains
heat exchanger : Cu /Al
heating medium : hot water
testing pressure : 20 Bar
max. working pressure : 12 bar
max. work temperature : 110°C
max. intake temperature : 40°C
motor-ventilatorgroup with one or more, dual intake, directly driven
centrifugal fans
motor with operating capacitor
motor isolation class : F
motor protection class : IP 31
tension 230 V, 50 Hz
Serie G9 : air curtains duo
heat exchanger : Cu /Al
heating medium : hot water
testing pressure : 20 Bar
max. working pressure : 12 bar
max. work temperature : 110°C
max. intake temperature : 40°C
two motor-ventilatorgroups with dual intake, directly driven
centrifugal fans
motor with operating capacitor
motor isolation class : F
motor protection class : IP 31
tension 230 V, 50 Hz
The ventilators are balanced according VDI 2060 norm.
The heating medium may not be corrosive.
I.2. Application area
The Verco air curtains are designed to be mounted on top of all
types of entrance and exit doors, providing a protective air screen to
separate cold external air from the warm air inside.
Any other use, or disregard of these specifications, is not allowed,
unless agreed otherwise. Any damage as a result of an unauthentic
use, will be accounted on the entire responsability of the user.
The air heaters may not be mounted in explosion hazardous rooms,
outside, in humid rooms, in rooms with a high concentration of dust
or agressive atmosphere, or in rooms with high electromagnetics
demands.
I.3. Modifications
Without prefatory approval of the manufacturer, no modifications or
alterations can be made to the air curtain.
I.4. Qualified personnel
Installation, electrical connection and repair are only to be performed
by specialists. Transport and commissioning are only to be performed
AIR CURTAINS
by trained service personnel.
Failure to comply with the specifications given by the manufacturer
will invalidate the guarantee.
I.5. Transport and storage
Verco air curtains are packaged to comply with normal transport
requirements.
Transport and store the air curtains in the original packaging.
On delivery, inspect the package and the air curtains.
In case of transport damage, the recipient should immediately
complain to the forwarding company and describe the damage on
the delivery note.
Compare the delivery note and the label on the air curtains.
The air curtains must be stored in the original packaging in a dry area
, and be protected against dirt and weather.
Avoid exposure to extreme cold or heat, above the 50°C,
temperatures. The heat exchanger can freeze open if temperatures
go below the freezing-point.
I.6. Safety instructions
The concerned safety prescriptions and the approved rules of
the technic should be followed in case of installation, electrical
connection and commissioning.
Power supply interrupted and secured.
Fan impeller has come to a stop.
Beware, after functioning, the air curtain can be hot, also the
accessories and piping.
Apply personnel safety regulations : wear safety shoes and gloves,
and a work dress.
I.7. Guarantee
The guarantee on the air curtains, in case of normal use, is 10 years
on the heat exchanger, 2 years on the fan and 1 year on the electrical
equipment, after delivery date. The guarantee covers only the
replacement of the broken components with exclusion of all other
costs.
Are also excluded of the guarantee :
- corrosion damage
- damage due to wrong installation, connection or treatement
- when the client failed to fullfill his obligations towards Verco
In case of a complaint, mention the fabrication number, sticked on
the casing, to Verco.
I.8. Manufacturer
Our products are manufactured in compliance with applicable
international standards and regulations.
If you have questions regarding the use of our products, please
contact :
Verco-Versichele N.V.
Karrewegstraat, 60 B– 9800 Deinze
Tel +32 -(0)9 / 386 48 46
Fax +32 -(0)9 / 386 83 63
E-mail : info@verco.eu
http://www.verco.eu
The manufacturer follows a politic of continuous improvement of his products,
and by these means attempts to make the needed adjustments to the products.
Therefore the manufacturer is entitled, without prior notification, to change a
component or characteristic of a product. This manual has the only purpose
to facilitate the installation, use and maintenance. It occurs that the given
information isn't in accordance with the product when the product is adapted