Programming; Programming A Remote Control Or A Keypad (Other Than A Keypad With Touch Screen) - hager S761-22 Guide D'installation

Programming

The remote-controlled socket can be programmed for
operation by up to 15 remote control devices (remote
controls or keypads). A remote control unit can control
an unlimited number of sockets as long as it has been
programmed to operate each one.
Programming must be performed:
• with the remote-controlled socket plugged
into the mains power outlet,
• with the device to be controlled deactivated,
• within 5 minutes after the socket has been plugged
into the mains power outlet.
After the first 5 minutes, you must deactivate the
device, then disconnect and reconnect the socket
to put it in programming or configuration mode again.
Programming a remote control
or a keypad (other than a keypad
with touch screen)
First programme the chosen key for one of the follow-
ing commands (see keypad or remote control installa-
tion guide):
• Light ON,
• Light OFF,
• Relays 1, 2, 3 or 4 ON,
• Relays 1, 2, 3 or 4 OFF
• Light in timer mode,
• Relays 1, 2, 3 or 4 in timer mode,
• Light in toggle switch mode,
• Relays 1, 2, 3 or 4 in toggle switch mode.
Perform programming as follows:
Press the
remote-controlled
socket
programming
key (for less
than 2 sec.).
The programming
LED will light programming LED
up temporarily.
If you make a programming error, the programming
LED will flash quickly. You must carry out the program-
ming sequence again from the start.
95
Press and hold
the programmed remote-controlled
key on the remote socket confirms
control or programming
keypad until the
programming
remote-controlled
socket LED lighting
up for 2 sec.
lights up
The
by its
G
B