Important - Bodum 11862-109 MOCCA Mode D'emploi

IMPORTANT

This product can be used with two different appliances for
INFORMATION
heating water to make coffee:
1 heating option with gas burner (a)
st
2 heating option with beam heater (b).
nd
These two products are explained below.
Prior to Using the Vacuum Coffee Maker
Clean the appliance prior to first use. To do so, fill the jug (3)
with water up to the 8 cup mark or 6 cup mark (ref. 11862-
109) or up to the 4 cup mark or 3 cup mark (ref. 11863-109)
and allow the appliance (gas burner or beam heater) to run
with the funnel lid (8), funnel (7) and its gasket (5) and filter
(6) in place.
Afterwards simply pour the water away.
Always place the gas burner (a) and beam heater (b) on a
stable, horizontal surface. This surface should neither be hot
nor near a heat/fire source. Do not operate the set upside
down or in a tilting position.
Make sure the appliance is used in only in a well-ventilated
environment.
Use the appliance at a safe distance from flammable
materials.
A distance of at least 30cm/12'' from a wall and 60cm/24''
from the ceiling are required.
Do not move the set during use.
Keep the set out of the reach of children.
PAY ATTENTION: There should always be a gap between the
MOCCA jug and the beam heater or the gas burner.
8
HOW TO USE THE
Open the jug lid (4) and fill the jug (3) with the desired volume
VACUUM COFFEE
of water. However, do not fill above the 8 cup line (ref. 11862-
MAKER
109) or the 4 cup line (ref. 11863-109) on the jug (3).
1 Brewing suggestion
st
STEP 1 Fill the jug with the required amount of preheating
water (6 to 8 cups - ref. 11862-109) or (3 to 4 cups - ref. 11863-
109) and place centrally over gas burner (a). Make sure the
appliance is used on a stable, horizontal surface.
STEP 2 Secure the filter (6) to the funnel (7) by pulling the filter
chain through the glass tube and fasten the metal hook onto
the tube end. Place the funnel (7) in the jug (3). Make sure it is
fully sealed. Place the lid (8) on top of the funnel.
STEP 3 Turn on the gas burner (around the knob) to release
gas (13) pre-filled in and light it. The water will rise through
the funnel.
STEP 4 Add the required amount of ground coffee to the
funnel (7). Ensure all the grounds are completely saturated by
giving it a gentle stir with the stirring spoon included. Let it
brew for 4 minutes. Place the lid (8) on top of the funnel.
ATTENTION: When the water comes up to the funnel (7)
some water will be left in the jug (3).
STEP 5 Turn off the gas burner after 4 minutes; the brewed
coffee will flow back into the jug (3).
STEP 6 Remove funnel (7) and pull on the filter (6) chain to
release the hook from the glass tube. Place the funnel on
the funnel holder (11). Now enjoy your coffee. To keep coffee
hot for longer, the jug lid (4) should be kept in place with the
heater (gas burner (a) or beam heater (b)) operated on low
power.
9
EN