Remote Control Pairing - TEMPUR-PEDIC Ergo Extend Smart Base Manuel Du Propriétaire

remote control pairing

The original remote that comes in the box is already paired to the adjustable base. No further action is
required. In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Locate the battery backup box and
press the button TWICE. A light
on the battery back up box will
illuminate.
Battery backup
box button
STEP 2
Remove the back cover of the
remote, press and hold down the
PAIR button. The PAIR button will
illuminate blue and start flashing.
When the PAIR button stops
flashing, the illuminated light on
the battery backup box will go
out. Release the PAIR button.
The remote is now paired to the
adjustable base.
PAIR
Button
STEP 3
Test all remote functions. If the remote buttons do not impact
the adjustable base movements, please repeat the process again
or call Tempur-Pedic customer service: U.S. 1-844-309-3597 |
Canada : 1-800-887-4321 | México: 01-722-273-1810
*ALTERNATE REMOTE PAIRING PROCESS
Locate the control box (see base overview on page
5) and press the button twice. A green LED light will
illuminate on the control box. On the back of the remote,
press and hold the PAIR button. The PAIR button will
illuminate blue and start flashing. When the PAIR button
stops flashing, the green LED light on the control box
will go out. Release the PAIR button. The remote is now
paired to the adjustable base.
9