6. Operation
• Power-Up
Connect the blinder to the mains. The red LED will light and the blinder will automatically self-test. The blue signal
indicator LED will only light in DMX mode. Refer to the table below to set the DIP switches.
1
ON
OFF
OFF = 0, ON = 1
Address code 10 – 11 – 12 is to select the required mode.
000 = DMX mode
001 = MASTER/SLAVE mode – auto mode
010 = MASTER/SLAVE – audio mode
011 = STAND-ALONE – auto mode
100 = STAND-ALONE – audio mode
101 = MASTER/SLAVE – auto + audio mode
110 = STAND-ALONE – auto + audio mode
111 = BLACKOUT mode
• DMX Mode
Set the address (1 to 511) using DIP switches 1 to 9.
DIP switch
1
Address
1
The DMX LED will flash when the unit receives a DMX signal.
Channel
From
0
41
71
101
1
131
161
191
221
• Master Mode
Select any of the 16 built-in programs using DIP switches 1 to 4.
o Auto Mode
The blinder automatically runs the built-in program. Brightness and speed can be adjusted through the controls
at the back: brightness (0 ~ 100%) and speed (80ms/step ~ 8s/step).
VDP7510S2
2
3
4
5
2
3
2
4
To
Description
40
All lamps are off.
70
10-channel mode: each lamp controlled separately.
100
5-channel mode: 2 lamps per channel.
130
2-channel mode: 5 lamps per channel.
160
1-channel mode: 10 lamps per channel.
190
3-channel mode: ch1 = built-in program, ch2 = brightness, ch3 = speed.
220
2-channel mode: ch1 = built-in program, ch2 = brightness.
3-channel mode with sound activation: ch1 = built-in program, ch2 = brightness, ch3
255
= speed.
6
7
8
9
4
5
6
8
16
32
5
10
11
12
7
8
64
128
9
264
HQPOWER