Switching Between Operating Modes - InnoCigs SC iStick Melo Manuel D'utilisateur

SC ISTICK MELO – SELECTION & OPERATING OF THE MODES

Switching between Operating Modes

Press the Fire button three times in quick succession to call up the menu and view your current vaping mode� Press
the adjustment buttons to switch between the VW ("Wattage"), Bypass, TC-Ni, TC-Ti, TC-SS316, TCR (M1, M2, M3)
modes� Press the Fire button once or just wait 10 seconds to confirm your current selection and leave the menu�
Adjusting the Wattage in TC/TCR Mode
The output power is between 1 and 60 W in TC and TCR modes� Press the Fire button 4x in quick succession to adjust
the wattage� You can adjust the wattage by pressing the "Up" or "Down" buttons�
Setting the TCR Value (M1, M2, M3)
While the device is switched off, press the fire button and the "Up" adjustment button simultaneously for a few
seconds to enter the TCR menu:
1� Press the fire button to switch between TCR M1, M2, and M3�
2� Press the "Up" or "Down" adjustment button to change the values corresponding to the coil of the head used�
3� Press and hold the fire button or wait for 10 seconds to confirm your settings�
54