InnoCigs SC iStick Melo Manuel D'utilisateur page 57

SC ISTICK MELO – SELECTION & OPERATING OF THE MODES
Locking and unlocking the Head Resistance in TC/TCR Mode
Simply hold down the Fire and "Up" buttons for two seconds in either TC or TCR mode to lock or unlock the base
resistance of the vaporizer� The "Lock" symbol will appear on the display� The "Ω" symbol will only appear again
when the vaporizer is unlocked�
Note:
1� This function should only be used at room temperature, to ensure that the correct "base resistance" is locked�
2� When you exchange the coil, the battery "saves" the resistance� This can increase if the temperature increases� If you
change the coil in Unlock mode, the display will show "New coil up same down" and the coil resistance can be reset�
If you are continuing to use the same coil, press the "Down" button� If you are using a new coil, press the
"Up" button� Please unlock the resistance if you would like to use an atomizer head with a different resistance�
3� If you accidentally use a conventional coil or coils with a resistance greater than 1�5 ohms in TC-Ni, TC-Ti, TC-SS or
TCR (M1, M2, M3) modes, the device will automatically switch to VW Mode�
55