Start-Up - Crowcon IR Display Instructions D'installation, D'utilisation Et De Maintenance

4. Start-up

The display detects the host IRmax. If the display has just been connected to a new IRmax,
it may take a few seconds to pick up the identifying address of the IRmax.
The LED at the right of the LCD goes momentarily to green, then to red and back to green.
The display shows:
• The name of the IRmax will display, scrolling if necessary, for 3 seconds
• The target gas - e.g. CH4 - will display briefly.
• The progress bar will then be displayed until the IRmax has warmed up.
If the host detector needs attention, appropriate warnings or status messages will be
displayed during or at the end of the warm-up phase. See Section 7, on page 13, for
further details.
Identification string can be configured during commissioning using the optional IRmax
PC communications kit.
While the Identification string is showing, pressing the keys below the panel will have no
effect.
When 'OK' shows at the top right of the screen, the display can be used to show
information.
If a Identification string has been assigned to identify the IRmax from which data is being
displayed, it may also show, possibly scrolling, at this time.
10