Crowcon IR Display Instructions D'installation, D'utilisation Et De Maintenance page 11

Carefully supporting the IR Display module if not yet fully installed, connect the other end
of the Molex lead to the IR Display Module (Diagram 7).
Diagram 7
Bring the IRmax and IR Display together.
Never twist the display by more than 45º from the normal vertical plane. Doing so
will result in damage to the connecting cable.
Holding the display housing still, tighten the joint by rotating the threaded collar clockwise.
Once the IR Display is firmly attached, its orientation can be adjusted by gently turning
the housing.
Add the bracket shown below.
Diagram 8
Installation Installation
7 7