Remote Display Options; Remote Ir Display - Crowcon IR Display Instructions D'installation, D'utilisation Et De Maintenance

Installation Installation

3.2 Remote display options

The IR Display can be used remotely from the IRmax, or alternatively it can be temporarily
connected to one or a number of IRmax detectors in turn. This mode of use is possible only
if the detector is purchased with an IS Barrier Module attached.

3.2.1 Remote IR Display

For use remotely from the detector, the IR Display is supplied in a glass-reinforced nylon
housing. Install the display permanently using a mounting bracket. Connect the display to
the IS Barrier Module via an IS cable using the pre-moulded 4-pin connector (see Diagram 9
below). A range of cables is available from 5 to 30 metres in length.
IS Barrier Module
Diagram 9
8 8
Mounting bracket
IS connecting lead
Terminals for
connection with
HART unit