PROUSER SC1600A Mode D'emploi page 8

LED Flashlight
To activate the built-in LED light, press the LED button (4). Pressing the LED button again switches
between the light-modes: continuous light, flashing light, SOS, OFF
Charging The Internal Battery
Before the 1st operation: This unit is delivered in a partially charged state, due to
storage requirements. Please fully charge the device after your purchase and before
your first use.
Battery Life
Recharging the battery after each use will prolong battery life. Do not permanently charge the battery,
but also avoid to (frequently) fully discharge the battery, as this will reduce battery life. Please recharge
the battery at least every 3 months to keep the battery in good condition and being able to jump start
at any time. Not charging the SC1600A every 3 months can cause a permanent damage to the internal
battery and can result in a broken unit.
Charging the internal backup battery with USB
Charge the device after buying and before first operation with the enclosed USB charging cable and a
common USB charger (not included) or with the USB output of your computer. Connect the micro-USB
cable to the USB input (8) of the jump starter and the USB output of your USB charger or computer.
Alternatively a USB power-bank with sufficient capacity can be used as a power source. The charging
state of the internal battery can be monitored on the LCD display when charging (13).
8
OPERATION