Description - Hilti C 4/36 Mode D'emploi

Symbols
Read the The disposal of
operating batteries with
instructions household
before use. waste is not
permissible.
Lock symbol For indoor use
only

2. Description

2.1 Use of the product as directed
The appliance is designed to charge Hilti Li ion batteries with a rated voltage of 4 to 36 volts.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
Tampering with or modification of the appliance is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Nationally applicable industrial safety regulations must be observed.
Observe the safety precautions and operating instructions for the accessories used.
To avoid hazards, use only batteries of the approved type.
The appliance is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
appliance and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
The appliance may be operated only when connected to an electric supply providing a voltage and frequency
in compliance with the information given on its type identification plate.
Do not use the battery as a power source for other unspecified appliances.
The C 4/36 and C 4/36 ACS chargers, with their radio frequency emission suppression measures, are designed
for use worldwide and especially in all EU and EFTA countries.
2.2 Items supplied as standard
1 Charger
1 Operating instructions
2.3 Charge status of the Li ion battery during charging
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
2
Return waste Equipped with
material for theft
recycling. protection
system
LEDs blink
LED 4
LED 3
LED 2
LED 1
Location of identification data on the appliance
The type designation and serial number can be found
on the type identification plate on the appliance. Make
a note of this data in your operating instructions
and always refer to it when contacting your Hilti
representative or service center.
Type:
Serial no.:
Charge status in %
= 100 %
75 % to 100%
50 % to 75 %
25 % to 50 %
< 25 %