Marmitek IR CONTROL PRO 8 Guide Utilisateur page 5

IR Receiver
09734
V+ Orange
(Max. 3)
G Blue
ST Purple
IR Yellow
To check the proper working of the system it is advisable first to test the formation as
planned. For this reason connect everything as described as follows but don't fix or screw the
components yet.
1. Install the IR Module at a place within reach behind or next to your A/V equipment and
near a 230V plug (230Volt/50Hz). Take into account the length of the cable of the IR
LEDs and make sure that the connections are kept accessible if possible.
2. Plug the required IR Extension cables (with the 2 IR LEDs) into the IR Module (Picture 1 nr. 4).
A self-adhesive foil is supplied with the IR LEDs. With that you can fasten the IR LEDs to
the IR window of your A/V equipment. Note: it's tricky work. First test the position and
working of the IR LEDs before fixing them permanently to the IR window of your A/V
equipment. Note: If you use only one of the 2 LEDs, then leave the second IR LED
unused. Never remove it from the IR extension cable!
3. Now connect the IR Receiver to the IR Module, for your convenience the connection clip
has been connected to the wiring of the IR Receiver, take care when plugging in of the
correct position (nuts up) and colours of the wiring. When you have to disconnect the
wiring for instance because a connecting clip won't go through a hole in the furniture,
connect afterwards the wiring to the clip according to the connection scheme in Picture 2.
4. Place the supplied IR receiver in such a way that it is visible for your infrared remote
control and if possible not in the vicinity of potential sources of disturbance like direct sun
light, TL lighting, energy saving lamps etc. Because of the supplied self-adhesive strip
installation is possible almost everywhere. Experiment for the correct place before you fix
the IR receiver definitively. Note: The adhesive strip can cause discoloration on certain
surfaces or leave glue remnants by removal.
5. Connect the power adapter to the 'POWER' connection of the IR module and plug the
adapter to a wall plug. (230V/50Hz). Check if the 'POWER' LED is on.
IR CONTROL PRO 8
V+
G
ST
IR
09733
Black
Black
-
White
TM
IR Module
1
2
3
4
IR LEDs
(Max. 4 IR extender cables)
Picture 2
5